Hasport Motor Mount Install
Tools Needed:
Floor Jack, Jack stands
Power Steering Fluid
Extension pipe (for socket)
Socket wrench
10mm, 14mm, 17mm, 19 mm sockets
Phillip screw driver
Hasport Motor Mount Kit
Silicone Lubrication spray can
Haynes manual book
Step 1: Jack up your car and remove tires on both side. Lower the car onto the jack stands. WE ARE NOT RESPONSIBLE FOR ACCIDENTS!
Step 2: Remove the rubber splash guards that is under the car. Use a 10mm socket and ratchet along with a Phillips screw driver to remove it.
Step 3: Position a jack under the engine oil pan. Place a large wood block between the jack head and the oil pan, and then carefully raise the engine enough to take the weight off the mounts.
Step 4: Disconnect the cable from the negative battery terminal on the battery.
Step 5: Use a 19MM to break all the motor mount bolts loose, we highly suggest doing one mount at a time and replacing as removed. You may have to Use a 19mm socket with beaker bar to remove that bolt of the torque mount in order to drop or raise the engine enough. Ours is located on the front of the motor.
Step 6: Remove each mounts fasteners, raise the engine with the jack and detach each mount from the frame bracket and engine.
Step 7: Install the new mount, making sure it is correctly positioned in its bracket. Install the fasteners and tighten them securely to spec.
For more information visit
www.hasport.com
Leave a Reply
Tuner Maneuver Magazine - Muskegon,MI
